FAA Airframe Rating · ACS Subject Area AM.II

FAA Airframe Practice Test

The FAA Airframe knowledge test is 100 questions, 2 hours, and a 70% pass mark — 70 correct answers. SkyLicense gives you free, ACS-aligned Airframe practice tests covering structures, hydraulics, landing gear, flight controls, fuel systems, and electrical, so you can simulate the real exam at a PSI testing center and walk in confident.

100

Questions

2h

Time Limit

70%

Pass Mark (70 correct)

AM.II

ACS Subject Area

Four questions from the Airframe bank

Straight from the SkyLicense question bank, in the real exam format: three choices, one correct answer. Open a question to read the explanation and the reference it cites.

Question 1 — open to see the answer

A helicopter pilot reports that the rotor brake is ineffective during shutdown. The mechanic inspects the system and finds the brake lining is worn beyond the manufacturer's limit. What is the correct action?

A. Adjust the brake cable to increase friction and return to service.

B. Replace the brake lining and return to service.

C. Return the helicopter to service and note the condition for the next inspection.

Answer: B

Worn brake linings reduce braking effectiveness and can lead to rotor overspeed during shutdown, which is a safety hazard. The correct action is to replace the lining with new parts per the manufacturer's maintenance manual and AC 43.13-1B, Chapter 7. Adjusting a worn lining is not a permanent fix and may not restore adequate braking. Returning to service with a known defect violates 14 CFR 43.13(a). Cleaning the disc does not address the worn lining.

Question 2 — open to see the answer

During a pre-purchase inspection, you find that an Airworthiness Directive (AD) has not been complied with. What is the correct action?

A. Inform the owner that the aircraft is not airworthy and cannot be returned to service until the AD is complied with.

B. Return the aircraft to service and note the overdue AD in the logbook.

C. Perform the AD and charge the owner for the work.

Answer: A

An overdue AD makes the aircraft unairworthy. The mechanic must inform the owner and ensure the AD is complied with before returning the aircraft to service. Returning to service with an overdue AD is a violation of 14 CFR 91.403. The mechanic cannot perform the AD without authorization from the owner.

Question 3 — open to see the answer

While inspecting the flight control system on a turbine-powered aircraft, you find that the aileron control cables have frayed strands near the turnbuckle. Which of the following is the correct action?

A. Replace the entire aileron control cable.

B. Replace the turnbuckle and the cable.

C. Splice the cable at the frayed section.

Answer: A

Frayed strands in a control cable are a critical defect that requires cable replacement. Per AC 43.13-1B, any cable with broken or frayed strands must be replaced. The turnbuckle should be inspected, but the cable is the primary issue. Splicing is not an approved repair for control cables. Tightening the turnbuckle will not fix the fraying. Reference: AC 43.13-1B paragraph 7-149.

Question 4 — open to see the answer

An A&P is performing a fuel system inspection on an aircraft equipped with a fuel return system. The mechanic notices that the fuel return line is disconnected and leaking. What is the correct action?

A. Reconnect the fuel return line and secure it with a new clamp.

B. Cap the fuel return line to prevent fuel leakage.

C. Note the discrepancy in the logbook and return the aircraft to service.

Answer: A

A disconnected fuel return line can cause fuel leaks and affect engine performance. The correct action is to reconnect the fuel return line and secure it with a new clamp to ensure a proper seal. Capping the line would disrupt the fuel system operation, and replacing the line is unnecessary if the existing line is in good condition. This follows AC 43.13-1B and 14 CFR 43.13.

How to Prepare for the FAA Airframe Test

  1. 1

    Learn the AM.II subject areas first

    Study each ACS subject area with the FAA Airframe Handbook (FAA-H-8083-31) and AC 43.13-1B before testing yourself.

  2. 2

    Take timed full-length simulations

    Run the 100-question, 2-hour Airframe simulation on SkyLicense. Practice pacing — you have about 72 seconds per question on test day.

  3. 3

    Review explanations and retake weak areas

    Use your per-subject score report to target weak topics, then retake simulations until you consistently score above 80%.

For a complete study plan, see the FAA A&P study checklist and the complete A&P licensing guide.

Airframe Practice Test FAQ

How many questions are on the FAA Airframe knowledge test?

The FAA Airframe knowledge test has 100 multiple-choice questions. You have 2 hours to complete it and must score 70% or higher — 70 correct answers — to pass. The test covers ACS subject area AM.II (Airframe).

What topics are covered on the FAA Airframe test?

The FAA Airframe test covers aircraft structures and airframe systems per the Aviation Mechanic ACS (FAA-S-ACS-1), subject area AM.II: metallic and composite structures, hydraulic and pneumatic systems, landing gear, flight controls, fuel systems, cabin atmosphere and pressurization, fire protection, and aircraft electrical systems.

Is the Airframe knowledge test required for an A&P certificate?

Yes, if you are pursuing the Airframe rating. Every mechanic candidate must pass the General knowledge test, plus the Airframe test for the Airframe rating and the Powerplant test for the Powerplant rating. Most mechanics pass all three and hold both ratings (A&P).

Where do I take the FAA Airframe knowledge test?

You take the FAA Airframe knowledge test at an FAA-approved computer testing center operated by the FAA testing service, PSI. You schedule the test after completing FAA Form 8610-2. The test is the same nationwide — 100 questions, 2 hours, 70% pass mark.

What is the passing score for the Airframe test?

The passing score is 70%. On the 100-question Airframe knowledge test, that means you must answer at least 70 questions correctly. The Airframe and Powerplant tests both use this rule, while the 60-question General test requires 42 correct answers.

How long should I study for the FAA Airframe test?

Most candidates study 4–6 weeks per knowledge test. Focus on the ACS AM.II subject areas, practice with timed simulations, and track your score per topic. When you can consistently score above 80% on practice tests, you are ready for the real exam.

Pass the Airframe Test with Confidence

Practice 100-question timed simulations, review ACS-aligned explanations, and track your score on every AM.II subject area.

Start Your Free Practice Test

Related FAA A&P Resources